Cut-To-Size FKM RUBBER STRAP USER MANUAL

Step 1: Attach the Strap

1. Release spring bars at the back by pushing the pin inward.

2. Place one end of the spring bar into the lug hole, then insert spring bars by pushing the pin inward. Make sure the spring bars snap into the lug holes.

Step 2: Measure the strap size

Wrap the strap around your wrist to identify the wrist centre line.
Start safe, leave at least one segment away from the center line on both the top and bottom straps.

Step 3: Trim the watch strap

⚠ Trim the strap at the groove. Once cut, it cannot be reversed.

Step 4: install the Clasp

Press to open the clasp before installing to the strap.

Attach the clasp to strap using a spring bar tool. Try installing it in the outermost hole first.

Reminder:
If it is difficult to install the spring bar into the middle hole of the clasp，try trimming the strap end neatly and evenly.

Step 5: Re-trim the strap / reinstall the clasp

Use a pin pusher to push the pin out of the clasp hole and gently slide the strap out.